Project Description
MA
ULTRASONIC ATOMIZER
Flow Rate
Liquid flow rate (lpm): min = 0,02 max = 2,87
Air flow rate (Nm3/h): min = 2,10 max = 36,2
Liquid flow rate (gpm): min=0,005 max=0,76
Air flow rate (scfh): min = 72,0 max = 1.290
Materials
Atomizer: 303 s.s.
Adapter: 303 s.s., Brass
More materials on request
MA
ULTRASONIC ATOMIZER
Flow Rate
Liquid flow rate (lpm): min = 0,02 max = 2,87
Air flow rate (Nm3/h): min = 2,10 max = 36,2
Liquid flow rate (gpm): min=0,005 max=0,76
Air flow rate (scfh): min = 72,0 max = 1.290
Materials
Atomizer: 303 s.s.
Adapter: 303 s.s., Brass
More materials on request
ATOMIZERS AND FITTINGS
Ultrasonic atomizers produce the finest sprays available with air assistance for industrial processes, with a narrow angle full cone jet.Water and air do not mix in a confined volume before leaving the nozzle, and therefore their feed pressures can be adjusted independently without influencing each other: this allows for a very wide regulation range on the liquid capacity and makes it easier to reach the desired operating conditions.Please note that the code given in the table only refers to the atomizing head and must be completed with the identification for one of the four connection adapters available,
AH | Air capacity | Ncm/hour | CA | Internal volume | liters | LP | Max operation pressure | bar |
AM | Air capacity | Nl/min | CH | Wrench size | mm | PA | Air pressure | bar |
AA | Atomizing air inlet | inch | HM | Max spray throw | mm | PL | Liquid pressure | bar |
AC | Cylinder air inlet | inch | HR | Lenght of coherent spray | mm | WH | Water capacity | l/hour |
An | Air nozzle code | — | LI | Liquid inlet size | inch | WM | Water capacity | l/min |
C | Spray width | mm | Ln | Liquid nozzle code | inch |
B and D adapter style allow for mounting the atomizer through a wall or the side of a duct. In this case, do not forget to order the VAM 2002 xxA locknut, which fits both, to hold the adapter in place.